MAXIMUM VELOCITY! ®
Extended Axle Holes & Weight Holes
for Pinewood Derby Cars
A high quality pine block with axles holes and weight holes for your shaping pleasure! The block is equipped with precision-drilled axle holes at an extended position.
You will get top performance from these blocks!
Precision Axle Holes - The axle holes are precision drilled to improve alignment and speed.
Raised Axle Hole - The front-left axle hole is drilled slightly higher so that the car runs on three-wheels. Tests consistently prove that three-wheel cars are faster than four-wheel cars.
Maximum Wheelbase - The axle holes are drilled to give the maximum length wheelbase. This increases stability, improves alignment, and enables the maximum benefit of weight placement.
The block is square on all sides, and measures:
- Height: 1-1/4 inch
- Width: 1-3/4 inch
- Length: 7 inches
- Hole Diameter: 13/32 inch
- Hole Depth: 1-1/2 inches
The block is equipped with precision-drilled axle holes. The holes are located 11/16" from the end of the block and are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).
The following standard options are available:
Option 9000: Drilled axle holes, 4 wheels on the ground - add $1.00.
Option 9001: Extended wheel base block with standard slots - add $1.00.
Option 9002: Drilled axle holes for Awana axles (3/32" bit) - add $1.00.
Option 9003: Wedge Cut Block - add $1.00.
If you would like a modification to this block, please Contact Us
describing the desired modification in detail. We will reply with a quote for the work. Please note that we do not sell completed cars.
Copyright © 2017 by Maximum Velocity, Inc.
® Maximum Velocity!
is a registered trademark of Maximum Velocity,
is a registered trademark of Boy Scouts of
is a registered trademark of Awana Clubs International.
is a registered trademark of PineCar.