MAXIMUM VELOCITY! ®
Standard Axle Holes & Weight Holes
for Pinewood Derby Cars
A high quality pine block with axle holes and weight holes for your shaping pleasure! The block is equipped with precision-drilled axle holes at the standard BSA position.
You will get top performance from these blocks!
Precision Axle Holes - The axle holes are precision drilled to improve alignment and speed.
Raised Axle Hole - The front-left axle hole is drilled slightly higher so that the car runs on three-wheels. Tests consistently prove that three-wheel cars are faster than four-wheel cars.
The block is square on all sides, and measures:
- Height: 1-1/4 inches
- Width: 1-3/4 inches
- Length: 7 inches
- Hole Diameter: 13/32 inch
- Hole Depth: 1-1/2 inches
The block is equipped with precision-drilled axle holes at the standard BSA position, and are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).
The following standard options are available:
Option 9000: Drilled axle holes, 4 wheels on the ground - add $1.00.
Option 9002: Drilled axle holes for Awana axles (3/32" bit) - add $1.00.
Option 9003: Wedge Cut Block - add $1.00.
If you would like a modification to this block, please Contact Us
describing the desired modification in detail. We will reply with a quote for the work. Please note that we do not sell completed cars.
Copyright © 2017 by Maximum Velocity, Inc.
® Maximum Velocity!
is a registered trademark of Maximum Velocity,
is a registered trademark of Boy Scouts of
is a registered trademark of Awana Clubs International.
is a registered trademark of PineCar.